A007 EPN (schematic)
Overview
Below you will find the schematic for A007 EPN as well as key operational features and additional support information to assist with your installation.
Installation Schematic A007 EPN
- The emergency door Buzzer circuit can be utilized to transmit the deactivation signal from RVT button to the module. The red wire on the RVT should be connected in this configuration to stop feedback onto the door buzzers.
- If there is no Buzzer circuit please use a direct connection from the RVT blue wire to the EP1plus blue wire
- The brown activation wire is typically connected to the red overhead lights or another 12V source (eg. brakes).
Operation Features
- Activation by the 8-way overhead red lights (or another 12V source)
- Deactivates in Key OFF position
- Front door is monitored and must be closed during deactivation
- 2 minutes to perform the child check
- Horn will sound for 5 minutes if the child check is not done
- To silence the horn, cycle the key off and then back to on
- Dome lights will illuminate for 2 minutes after deactivation
- Dome lights will flash twice to confirm deactivation
Order Information
Module: A007 EPN
Upgraded Component Kit: AC31 (For dome light, accessory and pilot light feature, LED not supplied)
- A033: RVT - Deactivation Button
- P100: 6-Pin Wire Harness
- A026: 3-Pin Diode Wire Harness
- P038: 2-Pin Wire Harness
