A007 ETP (schematic)
Overview
Below you will find the schematic for A007 ETP as well as key operational features and additional support information to assist with your installation.
Installation Schematic A007 ETP
- The emergency door Buzzer circuit can be utilized to transmit the deactivation signal from RVT button to the module. The red wire on the RVT should be connected in this configuration to stop feedback onto the door buzzers.
- If there is no Buzzer circuit please use a direct connection from the RVT blue wire to the EP1plus blue wire
- The brown activation wire is typically connected to the red overhead lights or another 12V source (eg. brakes).
Operation Features
- Activation occurs automatically after ignition has been on for 5 seconds
- Deactivates in Key OFF position
- The front door is monitored and needs to remain closed during deactivation
- Unlimited time to do child check and deactivate system
- Horn will sound for 5 minutes if the child check is not done
- To silence the horn, cycle the key off and then back to on
Order Information
Module: A007 ETP
Upgraded Component Kit: AC31 (For dome light, accessory and pilot light feature, LED not supplied)
- A033: RVT - Deactivation Button
- P100: 6-Pin Wire Harness
- A026: 3-Pin Diode Wire Harness
- P038: 2-Pin Wire Harness
